Local delivery and installation available in Auckland now!

Assembly Guide – HelloGarden Planter System

Self-Irrigating Planter System Checklist:

X 2 Long wall panels 1000 x 300 x 1.6mm (full return top & bottom edge)
X 2 Short wall panels 500 x 300 x 1.6mm (full return top & bottom edge)
X 4 SHS legs with rivnuts – 470 x 40 x 40 x 3mm
X 5 U-channel cross members – 15 x 18 x 2mm
X 1 Water tray base (watertight welded, locating tabs, overflow tube)
X 1 Water tray reservoir (U-channel)
X 1 Water tray inlet tube
X 16 Screws
X 8 End caps
X 4 Flatcar spacers (pre-drilled)

Assembly:

  1. Apply a bead of sealant around the interior surface of each rivnut hole (x2) and both return ends on the short wall panels

  2. Press each SHS leg section into the return ends ensuring pre-drilled holes in the leg section align with the corresponding holes in wall panel. Press down firmly allowing sealant to spread. Repeat assembly procedure with second wall panel and legs

  3. Complete assembly of second short wall panel and legs

  4. Apply a bead of sealant to the outer surface around each rivnut hole as well as both return ends’ surfaces of only one end of each long wall panel end. Align each spacer with a rivnut hole and press into position

  5. Align and press each long wall panel onto the SHS leg section on one assembled short end only ensuring pre-drilled holes (x4) in each leg section align with the corresponding holes in the long wall panel. Screw down tightly

  6. Drop each of x 5 U-channel support bars into position

  7. Slide the water tray base into position. Place the reservoir U-channel into the water tray base

  8. Apply a bead of sealant to the outer surface around each rivnut hole as well as both return ends’ surfaces of each unassembled long wall panel end. Align each spacer with a rivnut hole and press into position

  9. Align and press each long wall panel end onto the remaining assembled short wall section ensuring pre-drilled holes (x4) in each leg section align with the corresponding holes in the long wall panel. Screw down tightly

  10. Apply a bead of sealant at the join of the water tray base where it touches the interior wall surfaces. Allow 24 hours for the sealant to dry

  11. Lock water tray inlet tune into position

  12. Your HelloGarden planter system is now fully assembled